Spare Car Key Made at Your Car in San Diego

Value Car Keys cuts and programs a spare car key at your car anywhere in San Diego County. A chip key is from $125 and a push-to-start fob from $229 while one key works.

With one working key in hand, a spare is an add. We cut a new blade to match yours, plug a programmer into the car's OBD-II socket, and register the new key beside the old one. Nothing you already own stops working.

That is what separates a programmed spare from a duplicate cut at a key counter. The duplicate copies the metal; the spare is a key the car knows by its own chip, so it starts the engine and keeps working if the original is ever lost.

The price is the row for your key type below, and the drive to your car is part of it wherever you are in San Diego County. Against a dealer's typical quote, every key with a chip in the table runs 42 to 50 percent less, and why we cost less lays out where the difference comes from.

New spare car key held next to the original on its key ring at an open car door
The new key next to the original.

Spare car key prices

For spare car key, prices run $49 to $449 at your car, with the drive anywhere in San Diego County included. A dealer figure, where a row has one, is a typical San Diego dealership quote for the same job, before tax.

Prices as of 2026-09-30. Your exact price is confirmed on the phone before we drive.
Key or jobTypical dealerValue Car KeysYou keep
Basic metal key, no chipOlder cars and door-only keys, cut by code.No saving shown: the dealer is close on these, and you are paying for the house call. $40 to $90 $49 to $89 see note
Transponder chip keyPlain plastic head with a chip inside, on most 1998 to 2015 cars. The chip is the part a hardware store copy leaves out. $230 to $380 $125 to $199 $105 to $181
High-security laser-cut keyA groove milled down the center of a thick blade. Cut on the code machine in the van, then programmed. $270 to $450 $145 to $249 $125 to $201
Remote head keyButtons built into the head, flip keys included. The chip and the remote are each paired to the car. $300 to $450 $165 to $259 $135 to $191
Smart key for push-to-startThe fob arrives with an uncut emergency blade, and we cut it to your door lock before leaving. $400 to $750 $229 to $399 $171 to $351
European keyVolkswagen, Audi, BMW and 2013 and older Mercedes. We check the year and model against the VIN before driving. $380 to $900 $209 to $449 $171 to $451

Not sure which key you have? See the key types

How the visit goes

  1. Text a photo of your key and the year, make and model

    That, plus the plate or VIN, is enough to name the key type and give you one number with the drive inside it. You also get an arrival window, typically 45 to 90 minutes.

  2. Bring every key you own for the car

    The working key has to be there for add-key programming. On some makes, a key sitting in a kitchen drawer during the procedure can drop out of the car's memory and stop being recognized, so bring them all and none gets left behind.

  3. Cut first, then program through the port

    The blade goes on the van's cutter, by code or traced from your key. The programmer then plugs in under the dash, puts the car in add-key mode and registers the new key. Buttons are paired after that.

  4. Start it with both keys, then pay

    You start the car with the new key and with the old one, and press every button on each. Payment is by card or cash once they all work, and the warranty clock starts that day.

What a spare costs now, and what the same key costs later

With a working key present, a spare is priced as the key alone.

Once no key is left, the code comes off the VIN and the immobilizer is programmed from scratch, and that extra work adds $60: a Honda smart key is $239 as a spare and $299 with none left, against about $480 at a Honda dealer plus a $125 to $200 tow. The spare-key math works through more cars.

A car key duplicate from a key counter, or a programmed spare

A key machine copies the teeth. On most cars built since the late 1990s, the teeth only turn the lock; the engine runs only after a chip in the head answers the immobilizer.

A copy with no chip unlocks the door and turns the ignition, and then the engine cranks and stalls, or does not crank at all, depending on the make. Spare key won't start the car covers that case.

Some stores can clone the chip on certain older keys. Newer chips use encryption built to defeat copying, and laser-cut blades need a cutter most stores do not own. A clone also carries your original key's identity rather than its own, so if the original is ever lost and erased from the car, the clone stops working with it.

Cars that want the working key at the appointment

On many turn-key Fords, two working keys let you add a third, already cut, yourself with a timed ignition routine from the owner's manual. With only one key, the car needs a programmer, and that is the visit we make.

Older Toyotas split keys into a master with a black head and a valet with a gray head, and on many of them only the master can authorize a new key. On many Honda and Acura models, programming with no working key present drops every stored key from the car, and each one has to be registered again. If you are down to one key, lost car key replacement shows what the job becomes once it is gone too.

What the one-year warranty covers on a spare

The key, the remote buttons and the programming, for twelve months. If the key stops starting the car, a button quits, or the car forgets the key inside that year, we come back and put it right. A key that goes missing is not a warranty case. That is the job the spare was made for. The warranty page has the full terms.

Questions people ask

How much does a spare car key cost?

$125 to $199 for a chip key, $165 to $259 with remote buttons in the head, and $229 to $399 for push-to-start, with a working key present and the drive included. A dealer's typical quote for those keys is $230 to $750, with programming billed apart, typically $100 to $180.

Can you duplicate the car key I already have?

Yes, and the duplicate starts the car. With your working key at the car, we cut the blade by code or from your key, then program the new chip to the immobilizer as a key of its own: from $125 for a chip key and $229 for a smart key. Unlike a cloned copy, it keeps working if the original is later lost and erased.

Can I get a car key copied at a hardware store?

Only the metal part, on nearly every chip-key car. The chip that lets the engine run is either left out or cloned, and many newer chips cannot be cloned at all. Laser-cut blades need a machine most stores lack. A programmed spare is registered to the car as a key of its own, so it keeps working if the original is lost and erased.

Do I need my original key to make a spare?

Not strictly, but having it saves you $60. When a working key is present, the programmer uses add mode and simply registers the new key. Without one, the VIN supplies the key code and the immobilizer starts over from blank, which is priced as an all-keys-lost job and needs proof of ownership.

Will my old keys still work after you add a spare?

Yes. Adding a key leaves the existing ones registered, and we test each of them before we go. The exception is a car whose procedure rebuilds the whole key list, such as a Honda or Acura programmed with no working key on hand, which is why every key you own should be at the car for the visit.

Is your spare key the same quality as a dealer key?

Yes. The key is new and OEM or OEM-grade. It uses the chip type your original carries and is programmed with the procedure a dealer runs. What changes is the bill, which carries no showroom overhead and no labor line stacked on the part. Each key is covered for a year, buttons and programming included.

Can you make a spare for a push-to-start car?

Yes, for $229 to $399 against $400 to $750 at a dealer. Most makes need your working fob in the car while the new one is registered, and some Toyota and Lexus models add a built-in security wait that costs time, not money. The metal blade inside the new fob is cut to your door lock before we leave.

Get the spare made while one key still works

Call or text Value Car Keys at (619) 340-1518 with the car's year, make and model, from anywhere in San Diego County. If a dealer already quoted you, send that quote over for our answer on the same key.

Call (619) 340-1518Text us your car
Call me back

Every day, 7:00 AM to 9:00 PM.

Call (619) 340-1518Text us